文章詳目資料

先進工程學刊

  • 加入收藏
  • 下載文章
篇名 梯形微熱交換器之模擬探討
卷期 4:4
並列篇名 A Study on the Simulations of a Trapezoidal Shaped Micro Heat Exchanger
作者 鄧成忠張耀仁鄧治東
頁次 397-402
關鍵字 微熱交換器速度場溫度場不可壓縮納米亞-斯多克單相single phasetemperature fieldvelocity fieldincompressible Navier-Stokesmicro heat exchanger
出刊日期 200910

中文摘要

或冷卻。本文以模擬來探討梯形微熱交換器的流體流動和熱傳遞的特徵。此方法與傳統方法比較,分析結果相同。由這項研究,雷諾數得到從 0 到 165.7,為層流。最小的雷諾數是 0,發生在渠道邊緣,其速度為零;最大的雷諾數發生在入口歧管,有最大的溫度和速度。水入口溫度為 80°C,流率 0.0579 g/s,經由熱交換器可得到總熱通量為 12 W/cm2。

英文摘要

Micro heat exchangers are employed to heat or cool in cooling electronic devices, automobiles, chemical engineering and commercial and residential heating/cooling. A trapezoidal shaped micro heat exchanger was simulated to carry out fluid flow and heat transfer characteristics. These approaches are compared with the traditional method which the results are the same. For this study, the Reynolds numbers get from 0 to 165.7 which is laminar flow. The minimal Reynolds number is zero that occurs at the edge of channels where the velocity is zero, the maximal Reynolds number occurs at the inlet manifold where the temperature and velocity term are maximum. A total heat flux of 13.6 W/cm2 could be achieved from this heat exchanger for water with the inlet temperature of 80°C and flow rate of 0.1158 g/s.

本卷期文章目次

相關文獻